FTDX10 Setup of N1MM+, under configuration, AUDIO

 FTDX10 Setup of N1MM+, under configuration, AUDIO

On the Ftdx, do you use USB REAR as the setting?

Config -> hardware
1st line: Port = com7, Radio = FTDX10, digi and CW/other not checked, settings: 38400, N, 8, DTR = always off, RTS Always off, Radio NR = 1, Radio Polling Rate = Normal, none of the boxes are checked.

2nd Line: Port = Com8, Radio=none, CW/Other checked, Settings:DTR= CW, RTS = PTT, VFO Nr = 1, PTT delay = 50mS, no boxes checked, Two radio protocol = none, footswitch = none.

COM 7 and Com 8 are MY computer's assignments of the ENHANCED and STANDARD ports respectively.  Your port numbers will most likely differ.  Go to Device Manager -> PORTS (COM and  LPT) to find out.

 

 On FTDX10 Radio Setting:  Data Mod Source = Rear, Rear Select = USB, Rport Gain = 20, RPTT select = RTS.

 

 some settings were different that what I had….what about “digital modes” and “mode control”v